Waterproof M12 cable connector

Waterproof M12 cable connector

A cable gland is an important device that connects the two ends of a cable in order to connect it to an electrical device or other cable line. It is mainly used to seal the cable from moisture and to ensure proper functioning of the cable. The production process and treatment of cable glands is very important, because it directly affects the performance and life of the cable.

There are three main production methods for cable joints: dry wrapping, heat shrinking and cold shrinking. Among them, dry pack is suitable for indoor cable termination, heat shrink is divided into two kinds of paper insulation and crosslinking, which is suitable for different types of cables, while cold shrink needs to be made with the help of special plastic shell.

When making cable joints, you need to pay attention to the following points:

1. Select the appropriate type of cable gland. According to the use of applications, production materials and core materials, cable glands are divided into various types, such as heat-shrinkable, dry-wrapped and epoxy resin casting type. Choosing the right type of cable gland can improve the safety and stability of the line.

2. Prepare the required tools and materials. Before making cable glands, you need to prepare the required tools and materials, such as stripping pliers, cable glands, cables, heat-shrinkable tubes and so on.

3. Strip the insulation of the cable and wire it correctly. When making cable glands, you need to strip the insulation of the cable and connect the core wire of the cable to the core wire of the cable glands correctly.

4. Test the quality and effectiveness of the connection. After fabrication, the cable joints need to be tested to ensure their connection quality and effectiveness.

The selection of cable glands needs to consider factors such as material, core material, and installation place. When choosing cable glands, you need to make sure that it has sufficient loading capacity, and you need to choose a cable head that matches the cable.